Port Description; Cli Example - Dell PowerConnect M6220 Configuration Manual

console(config)#logging 192.168.10.65
console(Config-logging)#?
description
exit
level
port
console(Config-logging)#level ?
alert
critical
debug
emergency
error
info
notice
warning
console(Config-logging)#level critical

Port Description

The Port Description feature lets you specify an alphanumeric interface identifier that can be used for
SNMP network management.

CLI Example

Use the commands shown below for the Port Description feature.
Example #1: Enter a Description for a Port
This example specifies the name "Test" for port 1/g10:
console#configure
console(config)#interface ethernet 1/g2
console(config-if-1/g2)#description Test
console(config-if-1/g2)#exit
console(config)#exit
Example #2: Show the Port Description
console#show interfaces description ethernet 1/g2
Port Description
---- ----------------------------------------------------------
1/g2 Test
Specify syslog server description.
To exit from the mode.
Specify logging level.
Specify UDP port (default is 514).
Immediate action needed
Critical conditions
Debugging messages
System is unusable
Error conditions
Informational messages
Normal but significant conditions
Warning conditions
System Configuration
21