Cli Examples - Dell PowerConnect M6220 Configuration Manual

2 Inter-area (the source and destination are not in the same area, i.e., the route crosses the OSPF
backbone)
3 External Type 1
4 External Type 2
External routes are those imported into OSPF from other routing protocol or processes. OSPF computes
the path cost differently for external type 1 and external type 2 routes. The cost of an external type 1
route is the cost advertised in the external LSA plus the path cost from the calculating router to the
ASBR. The cost of an external type 2 route is the cost advertised by the ASBR in its external LSA.
NOTE:
The following example uses the CLI to configure OSPF. You can also use the Web interface. Click Routing >
OSPF or IPv6 > OSPFv3 in the navigation tree.

CLI Examples

Example 1: Configuring an OSPF Border Router and Setting Interface Costs
The following example shows you how to configure an OSPF border router areas and interfaces in the
switch.
VLAN 80
192.150.3.1
Figure 4-3. OSPF Example Network Diagram: Border Router
IPv4 (OSPFv2)
• Enable routing for the switch:
VLAN 50
192.150.2.1
VLAN 70
192.150.2.2
VLAN 90
192.150.4.1
IPv6 (OSPFv3)
Routing Configuration
69