Dell PowerConnect M6220 Configuration Manual page 52

uplink ports should be active; otherwise, all the internal ports in the Group will be brought down. By
default, the minimum active uplinks for a Group is 1, which means at least one uplink port should be
active for the Aggregator Group to be active.
console(config)#port-aggregator group 2
console(config-aggregator-2)#minimum active uplinks 2
console(config-aggregator-2)#
Example #12: Show Group MAC Address Table
Use the show bridge address-table [port-aggregator group < GroupId >] command to show the MAC
address table for a particular aggregator group.
parameter in the command and, if not specified, shows all the MAC entries in all the Groups.
console#show bridge address-table port-aggregator group 2
Aggregator Group: 2
Aging time is 300 Sec
VLAN MAC Address
----- ---------------- ------ --------------------
3 0006.2932.814D
1001 0006.2932.814B
Example #13: Show Group VLAN Table
Use the show vlan [port-aggregator group < GroupId >] command to show the VLAN table for a
particular aggregator group.
command and, if not specified, shows all the MAC entries in all the Groups.
console#show vlan port-aggregator group 2
Aggregator Group: 2
VLAN AggregatorGroup
----- ----------------
3 2
1000 2
console#show vlan
VLAN AggregatorGroup
52
Switching Configuration
[port-aggregator group <Group Id>
Port
1/g2
1/g17
[port-aggregator group <Group Id>
Type
------
Static
Static
Type
Type
Static
Static
is an optional parameter in the
Authorization
-------------
Required
Required
Authorization
is an optional