Reimaging Corrupted Devices; Restoring Lab Devices To A Clean State - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

If you are not using Preboot Services, boot the device with the imaging boot CD or DVD and
consider installing the ZENworks partition to enable auto-imaging without needing to supply the
CD or DVD. For more information, see
for Imaging Operations," on page
the ZENworks partition.

28.5.3 Reimaging Corrupted Devices

Without data loss or undue disruption to users, you can fix devices that have become misconfigured
or corrupted.
1. When a device needs to be fixed, have the user back up any files to the network that he or she
wants to keep (if possible).
2. Create and/or assign an appropriate imaging bundle to the device.
3. If it is a device with a ZENworks partition or it is PXE-enabled, the user should boot the device
from the ZENworks partition or the Preboot Services imaging server (via PXE) to find and
execute the assigned bundle. If you are using PXE, make sure that Preboot Services is installed
on your imaging server. For more information, see
page 397.
or
If the device does not have a ZENworks partition and is not PXE-enabled, the user should boot
the device with the imaging boot CD or DVD and restore the appropriate images manually.
4. After the image is laid down, restore any user files that were backed up to the network.

28.5.4 Restoring Lab Devices to a Clean State

You can restore devices to a clean state, removing any changes or additions made since the last time
you restored the image on that device. This is useful for updating lab devices.
The following steps assume that the devices are unregistered.
1. Create an image of a clean model device and store it on a ZENworks Linux Management
imaging server. For more information, see
page 405.
2. If you are using Preboot Services, make sure that ZENworks Linux Management is installed on
your imaging server. For more information, see
Server," on page 345.
3. If you are using Preboot Services and the devices are PXE capable, make sure that PXE is
enabled. For more information, see
or
If you are not using Preboot Services or the Linux partition, create an imaging boot CD or
DVD that points to the ZENworks Linux Management imaging server where the clean image is
stored. For more information, see
page 346.
Deploy each lab device as follows:
1. Physically connect the device to the lab network.
2. If you are using Preboot Services, boot the device from the Preboot Services imaging server.
Step 3 on page 355
394. After you have installed the partition, reboot the device from
Chapter 30, "Using Preboot Services," on
"Manually Taking an Image of a Device" on
Section 29.1, "Preparing a Preboot Services
Section 29.6, "Enabling PXE on Devices," on page
Section 29.2, "Setting Up the Preboot Services Methods," on
Understanding Preboot Services in ZENworks Linux Management 339
of Section 29.7.2, "Enabling a Device
392.