Configuring Preboot Services Defaults; Configuring Preboot Services Menu Options - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

IMPORTANT: If you add or subtract a menu option, make sure that you do the same thing to
each of the last three sections. The numbering should be consecutive (such as 1 through 5). Be
sure to keep the corresponding items matched in each of the last three sections.
4 When finished, save the pxemenu.txt file.

29.4 Configuring Preboot Services Defaults

You can configure Preboot Services default settings for a ZENworks Management Zone. These are
settings that apply globally to all devices in the management zone.
Some of these settings enable you to automatically register devices with the ZENworks Linux
Management server, and some can be overridden by configurations done for devices or folders
containing devices. For more information, see
Defaults," on page 390.
The following default settings can be configured in the ZENworks Control Center:
Section 29.4.1, "Configuring Preboot Services Menu Options," on page 371
Section 29.4.2, "Configuring Image Storage Security," on page 373
Section 29.4.3, "Configuring Non-registered Device Settings," on page 374
Section 29.4.4, "Configuring Preboot Work Assignments," on page 377
Section 29.4.5, "Configuring the Server Referral List," on page 384
Section 29.4.6, "Configuring Intel Active Management Technology (AMT)," on page 386

29.4.1 Configuring Preboot Services Menu Options

To determine whether the Preboot Services Menu should be displayed on your devices when they
boot:
1 In the ZENworks Control Center, click the Configuration tab, which displays the following
Management Zone Settings section:
2 In this section, click Preboot Services to display the configuration sections.
3 Locate the Preboot Menu Options
Section 29.5, "Overriding Preboot Services
section:
Setting Up Preboot Services 371