Using A Specific Network Card For Devices Running Dual Nics - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

Using a Specific Network Card for
I
Devices Running Dual NICs
You can chose to use a specific network card for a device running dual NICs by using one of the
following ways:
Modify the /srv/tftp/z_auto.cfg or the /srv/tftp/z_maint.cfg file (or both)
by adding the following line at the end of the Append command:
netdevice=eth0
In ZENworks Control Center, add netdevice=eth0 as an additional kernel parameter while
creating the AutoYaST bundle. For more information on how to create and configure the
AutoYaST bundle, see Section 30.3.1, "Configuring an AutoYaST Bundle," on page

Using a Specific Network Card for Devices Running Dual NICs

I
430.
653