Content Replication Schedule; Local Device Logging - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM PLANNING-DEPLOYMENT-BEST PRACTICES GUIDE 10.3 30-03-2010 System Planning Manual

Common variables are SOURCE_PATH or TARGET_PATH
Define variables for your Management Zone.
Define variables for your folders if you need different or additional settings.
Define variables in your bundles only if the above settings do not fit your needs.
The following is an example of system variables that are set at the Management Zone level. These
can then be used in bundles for distribution. Because these are set at the Management Zone level, it
is assumed that these variables are resolvable on any device registered in the Management Zone.
Figure 4-5
For more information, see "Content" in the
Administration

Content Replication Schedule

The content replication schedule defines how often a Primary Server that has assigned content
checks the database for updates (new content or deleted content).
Novell recommends changing the default value (5 Minutes) to at least 30 minutes to protect the
system from heavy loads that could lead to utilization issues. This gives you enough time to ensure
that content is always up-to-date across all your systems in the Management Zone.
Figure 4-6

Local Device Logging

Use a severity setting of Error for log messages. If you set the severity to Warnings and Above, you
might end up collecting more data than you really need. If you understand the errors you are
encountering, this is more than enough for troubleshooting your infrastructure.
This settings page allows you to set the rollup schedule for a specific time or date. We recommend
that you create a new log file every day to ensure accurate information for troubleshooting purposes.
52 System Planning, Deployment, and Best Practices Guide
System Variables in ZENworks Control Center
Reference.
Content Replication Schedule in ZENworks Control Center
ZENworks 10 Configuration Management System