Selecting The Migration Destination; Section 4.4, "Selecting The Migration Destination - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - MIGRATION GUIDE 10.3 30-03-2010 Migration Manual

Server: For the server hosting the eDirectory tree, specify either its DNS name or IP address.
This field is automatically populated when you select an eDirectory tree in the Tree field.
LDAP Port: Specify your LDAP port. The default port of 636 for SSL or 389 for non-SSL is
displayed. We recommend SSL for password protection across the wire. This field is
automatically populated when you select an eDirectory tree in the Tree field.
Use SSL: If you are using SSL, select this check box. This field is automatically set to the
previous selection when you select an item in the Tree field.
2 Click OK.
The Source eDir Tree section shows all available eDirectory information and initially displays
the organizations contained at that level. The Migration Source field also displays the tree
name.
3 To select the migration destination, continue with
Destination," on page

4.4 Selecting the Migration Destination

To identify and log into your migration destination Novell ZENworks Configuration Management
Management Zone:
Figure 4-3
1 Fill in the following fields to authenticate to your destination Management Zone:
Zone: This field is not displayed the first time that you access the Zone Login dialog box.
On the second and subsequent logins, any zone that you previously logged into using this
dialog box is available from the drop-down list.
40 ZENworks 10 Configuration Management ZENworks Migration Guide
40.
Migration Destination
Section 4.4, "Selecting the Migration