Verifying Your Services Router Installation - Linksys VGA2100 - One Analog Voice Gateway 3 Line Administration Manual

Linksys One Communications Solution
4

Verifying Your Services Router Installation

Once the Services Router has fully booted:
1. Connect your PC to any LAN port on the SVR3000 with a Category 5 RJ-45 to RJ-45
cable, open a command prompt and type in "ipconfig" to verify that the SVR3000 has
provided a 192.168.x.x address to your PCs Ethernet port.
2. Verify the following LED behavior:
SYSTEM LED Solid green when the Services Router is operating
properly. Flashes between green and red in one-
second intervals to indicate that a new image is
loading. When in cascade mode, flashes in
intervals of five seconds green and one second
red.
LAN LED Green to indicate a device is connected that port.
WAN LED Flashes green when there is activity on the WAN
port.
3. If the Services Router is not working, see Chapter 8: "Troubleshooting"
Chapter 4: Installation
Installing One Services Router
Connect the Services Router to power
57