Maintenance - Diamondback 500ER Owner's Manual

Press STOP twice to enter the Workout Summary mode.
Press the STOP key three times to reset the console and return to the Idle mode, or press START to restart
the Interval Trainer program.
Ending the Heart Rate Control Program
When the program time has elapsed or the STOP key is pressed, the Cool Down program will launch, followed by the
Workout Summary display.
Press START to restart the Heart Rate Control program or STOP to return to Idle mode.
MAINTENANCE
All Diamondback Fitness products are engineered for years of near‐silent operation. Let noise be your first indication
that a repair or adjustment is required. Please, discontinue use immediately and contact an Authorized Service
Technician or Diamondback Fitness Dealer if an unusual noise, scraping, knocking, grinding or vibration is detected.
Often, a minor issue will become a major repair if ignored and use is continued.
Prior to each workout, confirm that all adjustment levers and screws are tightened.
Your Diamondback Fitness 500Er is manufactured of the most durable materials available. The plastics are molded of
strong and chemical‐resistant ABS and PVC. The frame is produced of high‐tensile steel and protected with an
industrial‐grade, powder paint coating for the highest level of corrosion resistance. It is important to note however,
that perspiration can be extremely corrosive if allowed to accumulate on the machine. After training, always wipe
down the unit with a mild soap solution followed by a thorough drying with a clean towel. Locating a small spray
bottle and towel near the unit will help ensure that your Diamondback Fitness 500Er looks new for many years.
NOTE: Perspiration is very corrosive and if allowed to remain on the machine, will cause discoloration, fading,
rust and odors. Unfortunately, these conditions are not covered under the Warranty Policy.
34