Pm Wake Up Events - JETWAY 635CSR1A User Manual

DPMS (default)
Blank Screen
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
PM Wake-Up Events
Please refer to section 3-8-1

3-8-1 PM Wake up Events

CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
IRQ [3-7,9-15],NMI
IRQ 8 Break Suspend
Ring Power Up Control
MACPME Power Up Control
PCIPME Power Up Control
KB Power ON Password
Power Up by Alarm
x Month Alarm
x Day of Month Alarm
x Time (hh:mm:ss) Alarm
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
¡ ü ¡ ý ¡ ú ¡ û
F5:Previous Values
Ring Power Up Control
During Disabled, the system will ignore any incoming call from the modem. During Enabled,
the system will boot up if there's an incoming call from the modem.
MACPME Power Up Control
During Disabled, the system will ignore any incoming call from the EtherNet controller.
During Enabled, the system will boot up if there's an incoming call from the EtherNet
controller.
PCIPME Power Up Control
Initial display power management signaling.
This option only writes blanks to the video buffer.
horizontal synchronization ports and write blanks to the video
buffer.
PM Wake Up Events
Enabled
Disabled
Disabled
Disabled
Disabled
Enter
Disabled
NA
0
0 : 0 : 0
F6:Optimized Defaults
Menu Level >>
F7:Standard Defaults
37
Item Help
F1:General Help