Pm Wake Up Events - JETWAY S446R2A User Manual

This determines the manner in which the monitor is blanked. The choice are Suspend →
off, All Modes → Off, and Always On.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.

PM Wake Up Events

Please refer to section 3-8-1
3-8-1 PM Wake Up Events
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
IRQ [3-7,9-15],NMI
IRQ 8 Break Suspend
RING Power Up Control
MACPME Power UP Control
KB Power ON Password
Power Up by Alarm
x Month Alarm
x Day of Month Alarm
x Time (hh:mm:ss) Alarm
Move Enter:Select
¡ ü ¡ ý ¡ ú ¡ û
F5:Previous Values
Ring Power Up Control
During Disabled, the system will ignore any incoming call from the modem. During
Enabled, the system will boot up if there's an incoming call from the modem.
PCIPME Power Up Control
This will enable the system to wake up by PCI device Power Management function.
Initial display power management signaling.
This option only writes blanks to the video buffer.
horizontal synchronization ports and write blanks to the video
buffer.
PM Wake Up Events
Enabled
Disabled
Disabled
Disabled
Enter
Disabled
NA
NA
0 : 0 : 0
+/-/PU/PD:Value F10:Save ESC:Exit
F6:Optimized Defaults
34
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults