Table of Contents
Advertisement
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING!
For the SDRAM CLOCK is set at 133MHz, use only PC133
/PC2100-compliant DIMMs. When this motherboard operate at
133Mhz, most system will not even boot if non-compliant modules
are used because of the strict timing issues, if your DIMM are not
PC133/PC2100-compliant, set the SDRAM clock to 100MHz to
ensure system stability.
2-5 Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or
other system components.
damage to both your motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1. Read the documentation for your expansion card and make any necessary
hardware or software setting for your expansion card such as jumpers.
2. Remove your computer's cover and the bracket plate on the slot you intend to use.
3. Align the card's connectors and press firmly.
4. Secure the card on the slot with the screen you remove above.
5. Replace the computer system's cover.
6. Set up the BIOS if necessary.
7. Install the necessary software driver for your expansion card.
Failure to do so may cause severe
15
Figure 2-4
Advertisement
Table of Contents
