Lutron Electronics aurora Z3-1BRL Manual

For PhilipsR HueR smart bulbs*
Z3-1BRL
aurora – Always Ready smart
bulb dimmer
0301869-03
For PhilipsR HueR smart bulbs*
Rev. A
Z3-1BRL
06/2019
* Aurora dimmers are a ZigbeeR Certified Product
0301869-03
Rev. A and tested for compatibility with PhilipsR HueR
06/2019
lighting products
Required for Installation
Required for Installation
#1 Phillips
screwdriver
Connect
1
Pair with a smart bulb
If Using a PhilipsR HueR Bridge*
#1 Phillips
Search "PhilipsR HueR" and
a
screwdriver
download the app
Follow screen prompts
b
Settings > Accessory Setup > Add Accessory >
Connect
Friends of HueR Switch
1
If pairing directly to a PhilipsR HueR bulb
(no bridge)**
Pair with a smart bulb
Turn bulb OFF and then back ON; this enables bulb
a
pairing for 15 minutes
If Using a PhilipsR HueR Bridge*
b
6 sec
6
Search "PhilipsR HueR" and
a
< 4 in (10 cm)
download the app
Hold button until LED on the unit blinks slowly, ~9 seconds.
After 6 seconds the bulb will flash, continue to hold.
Repeat to add additional bulbs.
* Update to the latest app and HueR bridge software. Only compatible with PhilipsR
HueR square-shape bridge V2. Not compatible with round-shape bridge V1.
** For multi-location without a bridge, see the Advanced Install Guide at
Follow screen prompts
b
www.lutron.com/smartbulbdimmers
Settings > Accessory Setup > Add Accessory >
Friends of HueR Switch
If pairing directly to a PhilipsR HueR bulb
(no bridge)**
Turn bulb OFF and then back ON; this enables bulb
a
pairing for 15 minutes
b
Hold button until LED on the unit blinks slowly, ~9 seconds.
After 6 seconds the bulb will flash, continue to hold.
Repeat to add additional bulbs.
* Update to the latest app and HueR bridge software. Only compatible with PhilipsR
HueR square-shape bridge V2. Not compatible with round-shape bridge V1.
** For multi-location without a bridge, see the Advanced Install Guide at
www.lutron.com/smartbulbdimmers
* Aurora dimmers are a ZigbeeR Certified Product
and tested for compatibility with PhilipsR HueR
lighting products
Rotary knob Mounting base
HueR Bridge
+3 sec
3
6 sec
6
< 4 in (10 cm)
2
Mounting to a Toggle Switch
Make sure the bulb is ON
a
While the light is ON, place base
b
over the toggle switch as shown
Rotary knob
Install mounting base *
c
Attach knob to mounting base
d
* Having trouble with the installation?
Visit www.lutron.com/aurorasupport for more information.
LED indicator (behind button)
Button toggles lights on / off
Outer ring rotates to dim
lights up / down
Mounting base
OR
While holding the base
against the wallplate,
securely fasten using a
Phillips screwdriver
HueR Bridge
+3 sec
3
English
Align opening
with the toggle
switch