Lutron Electronics Spacer System SPS-300LD Installation Instructions

Installation Instructions for
Table Lamp Dimmer
Please Leave for Occupant
Read all instructions completely before
installation.
Use Spacer System infrared hand-held remote
TM
controls (SPS-4IT, SPS-FSIT) for programming
and recalling lighting scenes, remote dimming,
and switching from the palm of your hand.
Important Notes
1.
Caution: To avoid overheating and possible
damage to other equipment, do not use to
control motor-operated or transformer-supplied
appliances.
2.
Install in accordance with all national and local
electrical codes.
3.
Operate in ambient temperatures between 0°C
(32°F) and 40°C (104°F). For indoor use only.
4.
Device may feel warm to the touch during
normal operation.
5.
The recommended minimum load is 25 watts.
6.
Do not exceed maximum load rating of
dimmer.
7.
Device may not work with dioded lamps
(Sylvania Designer 16™ or Philips PAR-16™).
8.
Do not use dimmer to control fluorescent
lamps or touch lamps. For lamps with integral
3-way switches, switch should be set to full on
position.
9.
For lamps with integral dimmers, the integral
dimmer should be set to full bright position
before connecting the Spacer System
to the lamp.
10.
Do not paint dimmer.
11.
Clean control with a soft damp cloth only. Do
not use any chemical cleaners.
SYSTEM
TM
Incandescent / 120V Halogen Dimmer
SPS-300LD
120/127VAC, 50/60Hz 25W minimum, 300W maximum
dimmer
TM
"The Hand" Infrared Wireless Remote
TM
Control will not operate the Spacer
System Dimmers. Use Spacer
TM
System infrared hand-held remote
TM
controls only.