Red Hat DIRECTORY SERVER 8.1 Command Reference Manual page 119

Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
nsTaskExitCode
This attribute contains the exit code for the task. This attribute only exists after the task is completed
and any value is only valid if the task is complete. The result code can be any LDAP exit code, as
Section 5.4, "LDAP Result
listed in
an error.
This attribute value is set by the server and should not be edited.
Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
Any response other than 0 is an error.
nsTaskCurrentItem
This attribute shows the number of subtask which the task operation has completed, assuming the
task can be broken down into subtasks. If there is only one task, then nsTaskCurrentItem is 0
while the task is running, and 1 when the task is complete. In this way, the attribute is analogous to a
progress bar. When the nsTaskCurrentItem attribute has the same value as nsTaskTotalItems,
then the task is completed.
This attribute value is set by the server and should not be edited.
Parameter
Entry DN
Valid Values
Default Value
Syntax
Example
Description
cn=task_name, cn=task_type, cn=tasks,
cn=config
Any string
Case-exact string
nsTaskLog: example...
Codes", but only a 0 value equals success; any other result code is
Description
cn=task_name, cn=task_type, cn=tasks,
cn=config
0 (success) to 97
Integer
nsTaskExitCode: 0
Description
cn=task_name, cn=task_type, cn=tasks,
cn=config
0 to the maximum 32 bit integer value
(2147483647)
Integer
nsTaskCurrentItem: 148
1
cn=tasks
105