Tractel Minifor TR 10 Operating And Maintenance Instructions Manual
Portable wire rope hoist electric hoist
Hide thumbs
Also See for Minifor TR 10:
- Installation, operating and maintenance manual (114 pages) ,
- Operating and maintenance instruction manual (61 pages) ,
- Operating and maintenance instructions manual (21 pages)
Related Manuals for Tractel Minifor TR 10
Summary of Contents for Tractel Minifor TR 10
- Page 1 minifor ® Portable wire rope hoist electric hoist Operating and maintenance instructions Models - TR 10 - TR 30 - TR 30 S - TR 50...
-
Page 2: Table Of Contents
14. Trouble shooting ........................17 15. Regulatory inspections ......................18 Always concerned to improve the quality of its products, Tractel SAS reserves the right to modify the specifications of the equipment described in this manual. Tractel companies and their agents or distributors will supply on request descriptive documentation on the full range... -
Page 3: Minifor ® Hoist Safety Symbols
(i.e. record keeping) (i.e. record keeping) To ensure the on-going improvement of it’s products, Tractel SAS reserves the right, at any time, to apply any changes which it may deem useful to the minifor portable wire rope hoist as described in ®... -
Page 4: General Warning
7. When in use, never touch the minifor wire rope in writing by Tractel Inc. for USA or Tractel Ltd. for ® hoist. Canada. minifor spare parts in accordance with the ®... - Page 5 23. Other components meet the requirements of the Tractel Inc., Griphoist Division applicable safety regulations and are of the proper In order to keep improving its products, Tractel SAS quality, and assembled to form a safe system. reserves its right to apply any modification at any 24.
-
Page 6: Definitions
7. NOT adjust or repair the hoist unless a qualified not been qualified or manufactured by Tractel. person performed such adjustments or repairs 14. NOT apply the load to the tip of the hook or to 8. -
Page 7: Presentation
® minifor hoist is forbidden, the manufacturer or any ® Tractel entities will not be responsible for any damages due to such unauthorized use. Each minifor hoist is tested before shipment for 110% ® of its maximum rated load. -
Page 8: Functional Specifications
2. FUNCTIONAL SPECIFICATIONS (on request: other voltages and frequencies) TR10 TR30 TR30S TR50 Number of phase Rated load lbs. (kg) standard/with 220/440 660/1320 660/1320 (300/600) 1100/2090 (500/950) sheave (100/200) (300/600) Speed feet/min (m/min) standard/ 50/25 16/8 43/22 (13/6.5) 23/12 (7/3.5) with sheave (15/7.5) (5/2.5) -
Page 9: Securing The Load
the wire rope are able to come into contact with the limit levers on the hoist. max. 130 mm 4. The hoist must be wedged so that it does not move on its bearing face. 5. The platform on which the hoist is placed must have the required stability and strength to ensure safe operation. - Page 10 The main precaution to be taken is to avoid any wire rope should touch any object when tensioned obstacle against which the load or lifting wire rope could (Fig. 10) at any time. bear laterally or butt against. 4.4.2. Hoist suspended, direct slanted lifting This configuration requires a stable slanted plane on which the load is pulled and maintained (Fig.
-
Page 11: Setting Up
In this case, special care must be hoist (except for changing a fuse), by anyone other taken when tensioning (see section 11). than a technician trained and certified by a Tractel compagny. NOTE: If idler pulleys are used, be careful to position the limit stops as described in section 5.4... -
Page 12: Operating The Hoist
This a mandatory safety If the unit does not operate correctly, return it to a requirement. technician trained and certified by a Tractel company (also see section 5.3). 5.4. Limit stops and pulleys 6. OPERATING THE HOIST... -
Page 13: Shutdown - Storage
hanging on its control cord. Never turn over the control For the same reasons, the loose wire rope strand box (control cord entry downward) as this can result in must be kept away from any obstacle which could control mistakes. catch it and you should be careful to prevent the loose strand from becoming tangled in itself;... -
Page 14: Lifting Wire Rope
(at least once a year) by a technician trained and certified by a Tractel company. No greasing or Fig. 18 lubrication of the unit is required by the user. (For maintenance of the lifting wire rope, see section 9). - Page 15 Before Before initial Annual Every each Item to check Specifications setting- safety daily into- inspection years service - nameplate present and in good condition Condition of nameplate - information indicated is legible Conditions of mounting screws - Mounting screws and nuts in place and nuts - Mounting screws and nuts properly tightened - No signs of damage...
-
Page 16: Sheave Kit Minifor
notice utilisation minifor acier g 21 11. SHEAVE KIT minifor hoist ® (Fig. 25) Èlectronique Èlectronique Fig. 21 Fig. 25 11.2. Installation If sheave kit is used, the necessary wire rope length is at least twice the lifting height plus around 6 ft. (2 m) 11.1. -
Page 17: Operation
11.3. Operation 13. NAMEPLATE When operating the hoist with the sheave kit system, the operator must take special care to ensure that 13.1. Standard equipment the load does not turn in order to keep the three strands of the wire rope from becoming entangled (two loaded strands + loose strand). -
Page 18: Trouble Shooting
• Return the equipment to a shut. technician trained and certified by 4 - Feeble motor rotation with • Lack of torque on start-up a Tractel company if the power “groaning” (defective permanent condenser supply voltage or surges are not or motor winding coil burnout). -
Page 19: Regulatory Inspections
• If the wire rope is normal, send system. the minifor hoist to a technician ® trained and certified by a Tractel company. • Brake maladjusted. • Adjust the air gap. 7 - Load descent is no longer • Worn brake shoes. - Page 24 As we are dedicated to continuous improvement of our products, Tractel SAS reserves the right to modify the specifications of the equipment described in this manual. As a result, illustrations may not represent exactly the product you receive: components and/or design may differ.
Need help?
Do you have a question about the Minifor TR 10 and is the answer not in the manual?
Questions and answers