Getting Started
To launch the DXP-HT Project Wizard
Select the sample project (highlight "Sample Updated for DXPHT 1.3" in the Project Selection
List (on the Main Screen), and click the Open Project command button). This invokes the first
Wizard dialog: System Information, containing a summary of the system information for this
project.
Refer to the System Information dialog section on page 21 for details.
Once all the required information is entered in this dialog, you can proceed to the next dialog by
selecting the Next>> button. When no additional dialogs are required this button will be inactive.
When creating a new project it is important to go through each dialog in order, using the Next>>
button. This helps to insure that no information is missed and that the project configuration is
complete. Later, when editing the project, the Jump to list allows quicker and easier access to
specific dialogs.
When you create a new project, the Wizard dialogs become available as selections in
the Jump To list only after they have been populated with the required data. In this
case of the sample project, all Wizard dialogs are available since the project is
complete.
To Create a New Project
Click on the Create New Project command button. This launches the DXP-HT Project Wizard,
which steps you through the process of designing and configuring a control system.
DXP-HT v1.3 - Programmer's Guide
Introduction
17