Pptp/L2Tp Settings - D-Link DIR-130 - Broadband VPN Router User Manual

Secton 3 - Configuraton
PPTP uses TCP port 1723 for its control connection and uses GRE (IP protocol 47) for the PPP data. PPTP supports
data encryption by used MPPE.
L2TP uses UDP protocol to transport the PPP data. This is often encapsulated in IPSec encryption instead of
MPPE.
Enable Setting:
Check this box to enable.
Name:
Enter a name for your VPN.
Connection Type:
Select PPTP, L2TP, or L2TP over IPSec.
VPN Server IP:
Enter the VPN Server IP address which is the
LAN IP of the router. (i.e. 192.168.0.1).
Remote IP Range:
Assign a range of IP addresses. The assigned
IP range should be on the same IP network
but not the in the same range as your DHCP
IP range.
For example, if your network is 192.168.0.xxx
and you set the DHCP range to 192.168.0.100-
200, the remote IP range cannot be within
192.168.0.100-200.
Authentication
Select the desired authentication protocol (PAP/CHAP/MS-CHAP v2).
Protocol:
MPPE Encryption
Select the level of encryption (None/40-bit/128-bit).
Mode:
Authentication
Select a user group from the drop-down menu. You can create user groups in the Advanced > User Group section.
Database:
D-Lnk DIR-130 User Manual

PPTP/L2TP Settings

31