Ipsec Settings - D-Link DIR-130 - Broadband VPN Router User Manual

Secton 3 - Configuraton
Enable:
Check this box to enable IPSec.
Name:
Enter a name for your VPN.
Local Net/ Mask:
Enter the local (LAN) subnet and mask.
(ex. 192.168.0.0/24)
Remote IP:
Select Site to Site or Remote User for the
required VPN configuration.
• Site to Site - Network-to-network VPN in
which two entire LAN networks are virtually
connected across the Internet. If selected,
enter the destination gateway IP address in
the box which is the public WAN IP or host
address of the remote VPN server endpoint.
• Remote User – Client-to-server VPN in
which remote VPN clients can to connect to
the router from the Internet and access Local
Network resources.
Remote Local
If Site to Site is selected, enter the Destination
LAN Net/ Mask:
subnet and mask of the remote network.
(ex. 192.168.1.0/24)
Authentication:
Select Pre-shared Key or X.509 Certificate Authentication. One of these two authentication methods must be selected.
• Pre-shared Key - Manually enter ASCII passphrase in box.
• X.509 Certificate - For certificate authentication, certificates must be manually uploaded to the router. See the "Certificates"
section for details.
D-Lnk DIR-130 User Manual

IPSec Settings