T-Rex 25452 Manual

25452
25452B
2013 DODGE
RAM 2500/3500
TOOLS REQUIRED:
Socket and Ratchet Set
Flat/Phillips Screwdrivers
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE INSTALLATION.
to each vehicle and occasionally manufacture more than one body style of the same model. To assure your part is correct;
can be directed to info@trexbillet.com. In the event you do not have internet access please call 1-800-287-5900.
Step 1
Install the three u-nuts onto the three Z brackets. Take the three z brackets and install them into the bumper opening. On the
rear top lip of the bumper are holes, the z brackets will install onto the holes. Place the brackets at the holes and insert the hex
bolts from behind the bumper and through the holes, through the z brackets and place the washers and nuts on the bolts and
tighten (Fig 1). Note the barb on the u-nuts should be on the back side of the z bracket, the barb is indicated by the white arrow
in Fig 1. Now insert the billet grille into the bumper opening in the vehicle (Fig 2). On the back of the biller grille are three small
square tabs with a hole in the center, take the three sheet metal screws and insert them through the billet bars and through the
hole in the tabs, the end of the screws should align with the z brackets and the u-nuts, tighten the screws (Fig 3). Installation
complete.
Fig 1
2013 DODGE RAM 2500/3500
Bumper Billet
(3) Z Brackets
(3) 1" 1/4" 20 Hex Head Screw
(3) 1/4" Washers
(3) 1/4" Nuts
(3) U-Nuts
(3) #8 3/4" Sheet metal screws
(1) Bumper Billet
Fig 2
Page 1
25452
25452B
2013 DODGE
RAM 2500/3500
Auto makers offer varied models
All other inquires
Fig 3
Rev. 09/23/13