Download Print this page
T-Rex 20568 Quick Start Manual

T-Rex 20568 Quick Start Manual

Billet grille for 09-12 ford f150

Advertisement

Quick Links

20568
20568B
09-12 FORD
F150
TOOLS REQUIRED:
8mm, 10mm Socket and Ratchet
Jigsaw
Phillips Screwdriver
Die Grinder & sanding wheel
1/8" Drill Bit & Drill Motor
Masking Tape
Step 1
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE ATTEMPTING
INSTALLATION. The first step of the installation is to remove the factory grille
shell from the vehicle. There are a dozen 10mm nuts holding the grille shell to
the bottom of the hood and a black bracket at the lower part of the grille shell
that need to be removed.
Step 2
Once you have the grille shell removed use masking tape to cover the front of it
to prevent any scratches during installation. The center of the grille shell needs
to be removed. Cut across the to vertical bars near the sides of the grille shell
with a jigsaw. (Fig 1) Leave a little (1/2") of the material on the vertical bar. (Fig
2) Cut the cross hatch material also, cutting closer to the grille shell. The entire
center portion of the grille shell will come out in one piece. (Fig 2)
Step 3
Next use the die grinder to smooth out where the cuts were made. Go around the
entire inside of the grille shell and grind it smooth. (Fig 3)
Step 4
Once the inside of the grille shell is smooth, lay the billet grille into the opening.
(Fig 4)
Step 5
While holding the billet grille in the grille shell, turn the grille over so you can
work on the backside. There are 8 tabs on the back side of the billet grille. Make
sure the billet if flush with the front side of the grille shell and use a couple pairs
of vise grips to hold the tabs on the billet grille to the grille shell, this will keep
the billet flush while you install it. (Fig 5)
Step 6
Now you will drill a hole through the tabs on the billet grille. With the tabs secure
with vise grips drill through the hole in the tab and through the grille shell on
each of the tabs.
Thank you for purchasing a T-Rex Grille. 12/10/08
09-12 FORD F150
Billet Grille 1 Pc.
PARTS LIST
(2) 135 Brackets
(6) #10 Screws
(2) 6/32 Nylon Lock Nuts
(2) 1 1/2" Machine Screws
(6) #10 Flat Nuts
(1) Billet Grille
Fig 5
20568
20568B
09-12 FORD
F150
Fig 1
Fig 2
Fig 3
Fig 4
Page 1

Advertisement

loading

Summary of Contents for T-Rex 20568

  • Page 1 Now you will drill a hole through the tabs on the billet grille. With the tabs secure with vise grips drill through the hole in the tab and through the grille shell on each of the tabs. Fig 3 Fig 5 Fig 4 Thank you for purchasing a T-Rex Grille. 12/10/08 Page 1...
  • Page 2 Repeat this to the 5 remaining tabs. Remove the vise grips and masking tape. Reinstall the completed grille shell on the vehicle. Installation complete. Thank you for purchasing a T-Rex Grille. 12/10/08 Page 2...

This manual is also suitable for:

20568b