T-Rex 25567 Manual

25567
99-04 FORD
F250 / F350 and
EXCURSION
BUMPER BILLET
with
Factory Fog Lights
Tools Required:
7/16" Wrench
Drill
¼" Drill Bit
Read and understand instructions before attempting installation
Step 1
Place the billet insert in the center with the brackets in the opening first. Then align the insert as it will
mount in the opening. The bottom of the billet should be sitting on the plastic.
Step 2
The two brackets will sit on top from the rear of the bumper. Be sure the insert is correctly positioned and
then drill a ¼" hole at each bracket. Insert a screw in each hole and a flat clip from behind. Tighten both
screws.
Step 3
Installation of the billet bumper insert is complete. Thank you for purchasing your T-Rex billet grille.
25567
9 - 9 4 0
F250 / F350 and
EXCURSION
BUMPER BILLET
with
Factory Fog Lights
Hardware / Parts Included:
1 - Billet Bumper Insert (8 Bars)
2 - ¼-20 x 3/4 Bolts
2 - ¼-20 Nuts
2 - ¼ Flat Washers
2 - ¼ Lock Washers
11/17/03 T-Rex Truck Products Inc.
FORD