T-Rex 20567 Quick Manual

20567
09-12 FORD
F150 PLATINUM
TOOLS REQUIRED:
8mm, 10mm Socket and Ratchet
Jigsaw
Phillips Screwdriver
Die Grinder & Sanding Wheel
1/8" Drill Bit & Drill Motor
Masking Tape
Step 1
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE ATTEMPTING
INSTALLATION. The first step of the installation is to remove the factory grille
shell from the vehicle. There are a dozen 10mm nuts holding the grille shell to
the bottom of the hood and a black bracket at the lower part of the grille shell
that need to be removed. Use a thin plastic pry bar or putty knife to pry the
factory grill from the hood (Fig 1), there are several latches with clips anlong the
top of the grill that will pop loose (Fig 2). Start prying at the corner and move
along the grille as the latches pop loose. Use masking tape under the prybar,
putty knife to prevent scratches to the paint of the vehicle.
Step 2
Once you have the grille shell removed use masking tape to cover the front of
it to prevent any scratches during installation. The center of the two grille shell
openings need to be removed. Cut across the to vertical bars and along the
sides of the grille shell openings with a jigsaw (Fig 3). Leave a little (1/2") of
the material. Once the grille is cut it should look like (Fig 4).
Thank you for purchasing a T-Rex Grille. 10/1/09
09-12 FORD F150 PLATINUM
Billet Grille 2 Pc.
PARTS LIST
(14) #8 - 3/4" Screws
(14) #8 Nut Plates
(2) #10 - 1" Screws
(2) #10 Nut Plates
(2) Billet Grilles
20567
09-12 FORD
F150 PLATINUM
Fig 1
Fig 2
Fig 3
Fig 4
Page 1