Built-In Terminal; External Device I/O Terminal - Canon Vb-C60 - Ptz Network Camera Start Manual

Built-In Terminal

External Device I/O and Audio I/O are available on the rear of the camera.
Audio input terminal

External Device I/O Terminal

VB-C60 has two input and two output terminals for external devices.
VB-C60 Viewer and VK-Lite Viewer allow you to check the status of external device input and to
control external device output (→ dOperation Guide P.3-22).
External Device Input Terminals (IN1, IN2)
The external device input terminal consists of two pairs of terminals (IN1 and IN2). The "-" terminal
is connected to GND in the camera. When two cables are connected to the "+" and "-" terminals,
the electrical status of the connection between the terminals (whether or not current flows between
them) notifies the viewer of the event.
Sensors and switches connected to the terminals should be electrically separated
from each power supply and GND.
Note
Audio output terminal
External device
output terminals
External device input
terminals
3-5