Ceiling-Mounting With Dome Housing Vb-Rd51S-C/S (Option) - Canon Vb-C60 - Ptz Network Camera Start Manual

Ceiling-Mounting with Dome Housing VB-RD51S-C/S (Option)

Follow the steps below to mount the camera on the ceiling with Indoor Dome Housing (option).
See the outer view of the dome (→ P.3-2) to determine the mounting position and direction.
● Carefully read and observe the precautions in "Before Installation" (→ P.2-14).
● It is strongly recommended to use VB-C60B when using a dome housing.
Note
a WARNING:
Please contact the dealer where you purchased the camera, for installation
and checkups.
● The place or ceiling, to which a camera is installed, should be strong enough to
bear the weight of the camera plus its optional products, including Ceiling Mount
Cover and Indoor Dome Housing. Be sure to reinforce the ceiling as needed.
● Please be sure to regularly check for rust on screws and brackets and for screw
loose, to avoid injuries or damages to the camera caused by camera falling.
● It is not recommended to install the camera to places with heavy vibration. It may
cause mechanical problems.
● When wiring cables, pay much attention not to damage the indoor wiring or piping.
Side View of mounting
Roof space
In-Ceiling Bracket
1. Screw to the In-Ceiling Bracket with four screws
Use the screws supplied with the dome housing.
Safety Wire
Fix to an anchor
or structure
Dome
Step4 Camera Installation
LAN cable
Backside Ceiling Bracket
Ceiling board
VB-C60
Continued on the next page. a
2-19