Connecting Audio Components - Marantz AV8003 User Manual

ENGLISH
ABOUT BALANCED JACKS
• The balanced output connector uses a XLR
connector.
• The XLR connector for professional use is internally
wired in either of the following two systems.
1. European system
(Pin w = HOT, Pin e = COLD)
w q
HOT
e
GND
COLD
2. USA system (Pin w = COLD, Pin e = HOT)
COLD
w q
e
GND
HOT
• This unit uses the 1. European system.
When a preamp or main amplifi er adopting the
European system is connected using a cable with
XLR balanced connectors, the reproduced signal
may be inverted of phase.
12

CONNECTING AUDIO COMPONENTS

CD recorder
ANALOG ANALOG
OUTPUT INPUT
DIGITAL DIGITAL
L L INPUT OUTPUT
R R
R L R L
FM ( ( 75 FM 75Ω Ω ) ) GND GND AM AM
ANTENNA ANTENNA
COMPONENT COMPONENT
INPUT 1( ( TV TV) ) INPUT 2( ( DVD DVD) ) INPUT 3( ( VCR1
INPUT 1 INPUT 2 INPUT 3
TV TV( ( 1 1 ) ) DVD DVD( ( 2 2 ) ) VCR1( ( 3 3 ) ) VCR1 DSS/VCR2 DSS/VCR2( ( 4 4 ) )
VIDEO VIDEO IN IN OUT OUT IN IN
4 4 5 5 5 5 6 6 COAX. COAX.
1 1 2 2 3 3 OPT. OPT.
OPT. OPT.
DIGITAL IN DIGITAL IN DIGITAL IN DIGITAL IN DIGITAL OUT DIGITAL OUT DIGITAL OUT DIGITAL OUT
TV TV DVD DVD VCR1 VCR1 DSS/VCR2 DSS/VCR2
L L L L
R R R R
IN IN OUT OUT IN IN
The output audio signal from the TAPE OUT jack and
the CD/CD RECORDER OUT jack is the same signal
which is currently selected.
Caution:
• Do not connect this unit and other components
to mains power until all connections between
components have been completed.
Notes:
• Insert all plugs and connectors securely. Incomplete
connections may make noise.
• Be sure to connect the left and right channels
properly.
Red connectors are for the R (right) channel, and
white connectors are for the L (left) channel.
• Be sure to connect input and output properly.
• Refer to the instructions for each component that is
connected to this unit.
• Do not bind audio/video connection cables with
power cords and speaker cables this will result in
generating a hum or other noise.
Super Audio CD
Analog Audio
Digital Audio (coaxial)
BALANCED
L
Digital Audio (optical)
INPUT 1( ( TV TV) ) INPUT 2( ( DVD DVD) )
INPUT 1 INPUT 2
OUT
PUT
1
OUT
PUT
2
Y Y C C B B / / C C R R / / Y Y C C B B / / C C R R / / Y Y C C B B / / C C R R / /
P P B B P P R R P P B B P P R R P P B B P P R R
VIDEO VIDEO
INPUT 3 INPUT 3( ( VCR1 VCR1) ) INPUT 4 INPUT 4( ( DSS DSS / / VCR2 VCR2) )
VCR1) ) INPUT 4( ( DSS/VCR2 DSS/VCR2) )
INPUT 4 OUTPUT 1 OUTPUT 1 OUTPUT 2 OUTPUT 2
VCR1 VCR1( ( 3 3 ) ) DSS/VCR2( ( 4 4 ) ) DSS/VCR2 MONI. O MONI. OUT
MONITOR MONITOR ZONE ZONE TV TV( ( 1 1 ) ) DVD DVD( ( 2 2 ) ) IN IN OUT OUT IN IN OUT OUT
OUT OUT OUT OUT
OUT OUT S-VIDEO S-VIDEO CD/CDR BALANCED IN CD/CDR BALANCED I
REMOTE REMOTE DC OUT DC OUT
PUSH PUSH
1 1 1 1
IN IN
IR IR
FLASHER FLASHER RECEIVER RECEIVER
IN IN IN IN
2 2 2 2
EMITTER EMITTER
OUT OUT
MAIN MAIN ZONE ZONE OUT OUT R R L L
TAPE TAPE CD/CDR CD/CDR CD/CDR CD/CDR ZONE OUT ZONE OUT L L SL SL SBL SBL
OUT OUT IN IN OUT OUT IN IN IN IN OUT OUT OUT OUT A A B B R R SR SR SBR SBR
( ( AUX AUX) )
AUDIO AUDIO AUDIO AUDIO
R L R L
CONNECTING DIGITAL AUDIO COMPONENTS
• There are 6 digital inputs, 3 coaxial jacks and
3 optical jacks, on the rear panel. You can use
these jacks to input PCM, Dolby Digital and DTS
bitstream signals from a CD, DVD, or other digital
source components.
• There is one digital output coaxial jack and one
optical output jack on the rear panel. These jacks
can be connected to a CD recorder, or a MD deck
inputs, respectively.
• Refer to the instructions for each component. To
setup the digital audio format of DVD player, or
other digital source's connected to digital input
jacks.
• Use fi ber optical cables (optical) for DIG-1,2,3
input jacks. Use 75 ohms coaxial cables (for digital
audio or video) for DIG-4, 5, 6 input jacks.
• You can designate the input for each digital input/
output jacks according to your component. See
page 24.
Analog Audio (balanced)
UNBALANCED
L
R
Analog Audio (unbalanced)
R
R L
INPUT 1( ( TV INPUT 1 TV) ) INPUT 2 INPUT 2( ( DVD DVD) )
FM (75Ω)
GND GND AM AM
ANTENNA TENNA
C C C C C C C C
COMPONENT COMPONENT Y Y B B / / P P R R / / P P Y Y B B / / P P R R / / P P Y Y
B B R R B B R R
VIDEO VIDEO INPUT 3 INPUT 3( ( VCR1 VCR1) ) INPUT 4( ( DSS INPUT 4 DSS / / VCR2 VCR2) )
INPUT 2( ( DVD NPUT 2 DVD) ) INPUT 3( ( VCR1 INPUT 3 VCR1) ) INPUT 4 INPUT 4( ( DSS/VCR2 DSS/VCR2) ) OUTPUT 1 OUTPUT 1 OUTPUT 2 OUTPUT 2
VCR1( ( 3 3 ) ) DSS/VCR2( ( 4 4 ) )
VCR1 DSS/VCR2
VCR1( ( 3 3 ) ) R1 DSS/VCR2 DSS/VCR2( ( 4 4 ) ) MONITOR MONITOR ZONE ZONE TV TV( ( 1 1 ) ) DVD DVD( ( 2 2 ) )
IN IN OUT OUT IN IN
OUT OUT OUT OUT
Or
S-VIDEO S-VIDEO
OUT OUT IN IN OUT OUT
REMOTE REMOTE DC OUT DC OUT
COAX. COAX.
1 1 1 1
IN IN
IR IR
FLASHER FLASHER RECEIVER RECEIVER
IN IN IN IN
OPT. OPT. 2 2 2 2
EMITTER EMITTER
OUT OUT
DIGITAL OUT DIGITAL OUT MAIN MAIN ZONE ZONE OUT OUT
VCR1 CR1 DSS/VCR2 DSS/VCR2 TAPE TAPE CD/CDR CD/CDR CD/CDR CD/CDR ZONE OUT ZONE OUT L L
OUT OUT IN IN OUT OUT IN IN OUT OUT IN IN IN IN OUT OUT A A B B R R
AUDIO AUDIO AUDIO AUDIO ( ( AUX AUX) )
UNBALANCED UNBALANCED
BALANCED BALANCED
SELECTOR SELECTOR R L
Notes:
• There is no Dolby Digital RF input jack. Use an
external RF demodulator Dolby Digital decoder
when connecting the Dolby Digital RF output jack
of the videodisc player to the digital input jack.
• The digital signal jacks on this unit conform to
the EIA standard. If you use a cable that does not
conform to this standard, this unit may not function
properly.
• Each type of audio jack works independently.
Signals input through the digital and analog jacks are
output through the corresponding digital and analog
jacks, respectively.
L L
R R
OUT OUT
PUT PUT
1 1
SR SR SL SL
OUT OUT
PUT PUT
2 2
R R
C C C C SBR SBR SBL SBL
B B P P / / R R / / P P
B B R R
SW SW C C
MONI. OUT MONI. OUT
OUT OUT SB SBR
UNBALANCED UNBALANCED
RS-232C RS-232C
CONNECTION
CD/CDR BALANCED IN CD/CDR BALANCED IN
1 GND
CD/CDR IN CD/CDR IN 2 1 2 HOT(+)
PUSH PUSH PUSH PUSH
3
3 COLD(-)
3 3 AC IN AC IN
2 1 2 1 UNBALANCED UNBALANCED UNBALANCED UNBALANCED
BALANCED BALANCED BALANCED BALANCED
R R R R L L L L SELECTOR SELECTOR SELECTOR SELECTOR
SL SL SBL SBL C C
7.1CH 7.1CH
IN IN
SR SR SBR SBR SW SW
UNBALANCED UNBALANCED
BALANCED BALANCED
SELECTOR SELECTOR