Steps For Testing Dirmaint; Step For Modifying The Operator's Directory Entry - IBM ZVM - FOR LINUX V6 RELEASE 1 Getting Started

7.
8.
You are done.

Steps for testing DirMaint

This procedure tests DirMaint. The command you use allows MAINT to issue
DirMaint commands without a password.
Before you begin: You need to know the password for MAINT.
Perform these steps to test DirMaint:
1.
2.
3.
You see these messages:
You are done.

Step for modifying the OPERATOR's directory entry

In Chapter 9, "Setting up basic system automation," on page 85, you set up the
programmable operator facility, which requires that the OPERATOR virtual
machine automatically load (IPL) CMS when it is logged on. This procedure uses
DirMaint to modify the OPERATOR's directory entry to include a statement that
loads CMS.
Before you begin: You need to be logged onto MAINT.
60
z/VM: Getting Started with Linux on System z
Save the file. At the XEDIT command line, type this command and press the
Enter key:
====> file
Detach the 091 minidisk (AUTOLOG1's 191). Type this command and press
the Enter key:
release z (det
Ready;
Log onto MAINT.
From the CMS command line, type this command and press the Enter key:
dirm needpass no
When prompted, type MAINT's password and press the Enter key.
dirm needpass no
DVHXMT1181R Enter the current logon password of MAINT at DVHTEST6 for
DVHXMT1181R authentication. It will not be displayed on the
DVHXMT1181R terminal. To exit without processing the command, just
DVHXMT1181R press ENTER.
DVHXMT1191I Your NEEDPASS request has been sent for processing.
MAINT AT DVHTEST6; T=0.05/0.06 18:53:02
DVHREQ2288I Your USEROPTN request for MAINT at * has been accepted.
DVHBIU3450I The source for directory entry MAINT has been updated.
DVHBIU3456I Object directory update is not required for this source
DVHBIU3456I update.
DVHREQ2289I Your USEROPTN request for MAINT at * has completed;
DVHREQ2289I with RC = 0.