Steps For Putting The Configuration Into Production And Starting Dirmaint - IBM ZVM - FOR LINUX V6 RELEASE 1 Getting Started

|
|
|
|
Steps for putting the configuration into production and starting
DirMaint
58
z/VM: Getting Started with Linux on System z
Perform these steps to copy the current USER DIRECT file:
1.
Link to MAINT's 2CC minidisk:
link maint 2cc 2cc mr multiple
2.
Access the 2CC minidisk (MAINT's 2CC, which is linked to 6VMDIR10):
access 2cc z
3.
Copy MAINT's USER DIRECT file to 6VMDIR10's J-disk as USER INPUT:
copy user direct z user input j
4.
Release the linked minidisk:
release z (detach
Continue with the next steps.
In these steps, you place the DirMaint configuration into production and start
DirMaint.
Before you begin: You need to log onto 6VMDIR10. Later, when you log onto
DIRMAINT, you need to know the log-on password you defined in "Steps for
changing the passwords for DirMaint service machines" on page 52.
Perform these steps to put the configuration into production and start DirMaint:
1.
From the CMS command line, type this command and press the Enter key:
dir2prod prod 6vmdir10 dirm
2.
Log off 6VMDIR10. Type this command and press the Enter key:
logoff
3.
Log onto DIRMAINT.
4.
Start the DirMaint program:
dvhbegin
. .
.
DVHWAI2140I Waiting for work on 04/02/09 at 18:47:38.
5.
Disconnect DIRMAINT. Type this command and press the Enter key:
cp disc
Continue to the next steps.