Table of Contents
Advertisement
====> all/NCCF
====> delete *
====> all
6.
Save the file. From the XEDIT command line, type this command and press
the Enter key:
====> save
7.
Move the current line to the line before "SEND ALL OTHER TRAPPED DATA
TO THE LOGICAL OPERATOR". From the XEDIT command line, type these
commands and press the Enter key after each one:
====> bot
====> u3
====> set case mixed
"SET CASE MIXED" instructs XEDIT to keep characters you enter in mixed
case.
====> input
8.
Add these lines. Remember to keep entries in their proper columns and keep
characters in mixed case as shown.
Note: These lines filter many messages. Over time, you might want to remove
some if you find you do not use them or want to handle certain
messages in other ways, such as logging them.
*------------------------ --- --- -- -------- -------- -------- --------
* NOTIFY LOGICAL OPERATOR IF LINUX ABENDS
*------------------------ --- --- -- -------- -------- -------- --------
/OOPS/
$DISABLED
$PSW$
$psw$
$disconnected/
/HCP$
$FAILURE/
$failed/
$Failed/
$No such/
$ERROR/
$error/
$_MACHINE$
$cannot open/
*------------------------ --- --- -- -------- -------- -------- --------
* DON'T WORRY ABOUT ANY OTHER SCIF OUTPUT FROM MONITORED USERS
*------------------------ --- --- -- -------- -------- -------- --------
*------------------------ --- --- -- -------- -------- -------- --------
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
DMSPOS
8
Chapter 9. Setting up basic system automation
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
LGLOPR
91
Advertisement
Table of Contents
