Flip-Flop - American Audio DCD-PRO610 Operating Instructions Manual

ADVANCED OPERATIONS

FLIP-FLOP™

This feature is a kind of "auto pilot. " "Flip-Flop™" mode can only function with the both drives of
the DCD-PRO610. The "Flip-Flop™" function may be used with or without an American Audio
deck mixer. With "Flip-Flop™" you can have one unit begin playback when the other ends. You can
"Flip Flop" single tracks, the entire disc, a combination of the two, or you can even "Flip-Flop" your
programmed tracks.
To FLIP-FLOP™ single tracks or programmed tracks:
1) Connect your system as described in the set up section on page 6.
2) Set your mixer's crossfader to the center position.
3) Be sure your two units are single mode. SINGLE (67) should be indicated in the LCD (14).
4) Load your two DCD-PRO610 with audio disc.
5) After they have both cued, press the PLAY/
PAUSE BUTTON (29) on one of your drive to
begin playback.
6) After the first cds' single track has ended the
second cds' track will immediately begin play-
back.
7) Flip-Flop™ will continue until you stop it or
power is interrupted.
8) To deactivate Flip-Flop™ mode, repeat step 4.
To FLIP-FLOP entire CDs:
To FLIP-FLOP an entire disc, be sure both drives are in continuous play mode. The SINGLE ICON
(67) should not be displayed in the LCD (14). When both drives are in continuous play mode, follow
the directions for single track FLIP-FLOP as detailed above. When one the disc in one unit ends the
other unit will immediately begin playback.
Combining FLIP-FLOP modes:
Flip-Flop modes may combined. One unit may run in single mode and the other in continuous mode.
When the units are arranged in this fashion, the unit in single mode will play a single track and flip to
the next unit. The next unit will then play the entire disc and flip back to the other. The other will then
play the next track and flip back to the other unit, and so on.
Fader Q-Start™
This function works in conjunction with a compatible American Audio
mixer. When used with a compatible mixer, you can use the crossfader to start and stop the CD Player
with the slide of the mixer's crossfader.
Connecting your DCD-PRO610 to a "Q" Start mixer for "Q" Start control: Be sure to connect 1/8"
mono mini plugs from the control connection on the rear your DCD-PRO610 to the 1/8" control jack
on the rear of a American Audio
Scratch Box™ Compatible
The optional American Audio
The Scratch Box™ device is used in conjunction with any turntable and any Scratch Box™ compatible
American Audio CD player. For details of the optional Scratch Box refer to page 28.
®
"Q" series mixer. That's it, you'll be set for "Q" Start!
®
Scratch Box is a devices that simulates real time scratching of a CD.
®
American Audio • DCD-PRO610™ INSTRUCTION MANUAL • PAGE 25
®
Figure 36
or American DJ
®
"Q"
®
"Q-Start"
®