Relay (Flip-Flop); Looping - American Audio DCD-PRO210 Operating Instructions Manual

BASIC OPERATIONS (CONT)
12. RELAY (FLIP-FLOP™)
This feature is a kind of "auto pilot. " "Flip-Flop
the DCD-PRO210. The "Flip-Flop
American DJ "Q" deck mixer. With "Flip-Flop
®
the other ends. You can "Flip Flop
can even "Flip-Flop
To FLIP-FLOP single tracks or programmed tracks:
™
1) Connect your system as described in the set up section on page 6.
2) Set your mixer's crossfader to the center position.
3) Load disc drives with audio discs.
4) Press the RELAY BUTTON (6), the LED above the RELAY BUTTON will light up letting you know that
Flip-Flop mode has been activated. Press the SINGLE BUTTON (14) to choose between SINGLE
™
mode or CONTINUOUS mode.
5) After they have both cued, press the PLAY/
PAUSE BUTTON (3) on one of your drives to
begin playback.
6) After the first cds' single track has ended the
second cds' track will immediately begin play-
back.
7) FLIP FLOP will continue until you stop it or
™
power is interrupted.
8) To deactivate Flip-Flop
RELAY BUTTON.
13. CREATING AND PLAYING A LOOP
A loop is a sound loop that plays continuously. You can use this loop to create dramatic effect in your mixing.
This loop has no time limit and you could actually loop the entire length of disc. You create a loop between
two continuous points of a disc.
�� � �
TRACK
2)
Press the LOOP BUTTON (2). This will set the starting point
of the Loop (figure 21). The LED above the LOOP BUTTON
(2) will blink.
�� � �
TRACK
Figure 22
American Audio
©
" function may be used with or without an American Audio
™
" single tracks, the entire disc, a combination of the two, or you
™
" your programmed tracks.
™
mode, press the
™
������
�������
M S F
���
������
�������
M S F
���
- www.AmericanAudio.us - DCD-PRO210™ Instruction Manual Page 18
®
" mode can only function with the both drives of
™
" you can have one disc drive begin playback when
™
�� � �
TRACK M
1) Press PLAY/PAUSE BUTTON (3) to activate playback
mode.
Figure 20
3) Press the LOOP BUTTON (2) again to set the ending point
for your Loop (Figure 22). The LED above the Loop Button
will stay lit indicating a Loop is playing. Press the LOOP
BUTTON again to cancel the Loop.
������
�������
S F
���
Figure 19
�� � �
TRACK M
�� � �
TRACK M S
Figure 21
�� � �
TRACK M
or
®
������
�������
S F
������
�������
F
���
���
������
�������
S F
���