Managing A San Library; Managing A Lan/Wan Replication Library - HP StorageWorks 12000 User Manual
Hp storageworks 12000 gateway virtual library system user guide (ah814-96015, september 2010)
Hide thumbs
Also See for StorageWorks 12000:
- User manual (266 pages) ,
- Manual (218 pages) ,
- Design manual (160 pages)
Table of Contents
Advertisement
LAN/WAN libraries. See "Managing a SAN Library" on page or "Managing a LAN/WAN Replication
Library" on page .
An unmanaged library is a library that is not recognized by and using automigration or replication.
The process for unmanaging destination libraries is the same for both SAN and LAN/WAN libraries.
See
"Unmanaging a SAN or LAN/WAN
Managing a SAN Library
To manage a SAN library:
1.
Open the Automigration/Replication tab.
2.
From the task bar, select Manage SAN Automigration Library.
The screen displays all eligible libraries. Libraries that appear on the list but are greyed out either
have no drives or have multiple drive types and therefore cannot be managed. Also, if there are
no unmanaged drives, the system will return the message, "There are no unmanaged libraries."
3.
If the library you wish to manage is not already selected, select it now.
NOTE:
You can only select one library to manage at a time. To manage additional libraries, repeat
the procedure for each library to add.
4.
Select Submit.
The Destination Library Details screen displays, with the message, "The library, [library name],
was managed successfully."
You can now create pools for the library and manage your data on the library using automigration.
You can also unmanage the library at any time. See
Library" on page 53 for instructions.
Managing a LAN/WAN Replication Library
To manage a LAN/WAN replication target:
1.
Select the Automigration/Replication tab.
The Summary for All Managed Destination Libraries screen displays.
2.
Select Manage LAN/WAN Replication Library from the task bar.
3.
Enter the name or IP address of the host containing the LAN/WAN replication target you just
created.
4.
Select Submit.
5.
On the next screen, select the LAN/WAN replication target to manage.
6.
Enter the password you created for that target.
7.
Select Submit.
The LAN/WAN replication target is now associated with the source.
You must re-manage a LAN/WAN replication target if you change the password for security reasons.
To re-manage a LAN/WAN replication target:
52
Automigration/Replication
Library" on page 53.
"Unmanaging a SAN or LAN/WAN
Advertisement
Table of Contents
