Physical Capacity; San Health - HP StorageWorks 12000 User Manual

2. In some cases, there are more data points than the graphs can display. You must select how the
system chooses which data point to use for each time period displayed. For example, if you show
four days of data the graphs show one data point for every four-hour period. Use the Advanced
Setting list to indicate which data point out of that four-hour period is used:
• First data point — the first data point for each time period.
• Maximum data point — the data point with the highest value for each time period.
• Minimum data point — the data point with the lowest value for each time period.
3. Select a specific virtual library to view from the list, or use "VLS Device" to include all libraries
(Logical Capacity tab only).
4. Select Update Graphs. The graphs update to reflect the data options you chose.
NOTE:
The final graph displays the history of the logical capacity for the entire VLS and does not change if
you choose to view a specific library.

Physical Capacity

This tab displays different views of the physical capacity usage for an individual library or the entire
VLS system. Physical capacity is the amount of data actually stored on the disk, while the logical
capacity is the amount of data the backup application wrote. In a deduplicated environment, the
physical capacity reported represents data after compression and deduplication; without deduplication
it represents data after compression.
To export the physical capacity CSV data, enter the number of days to include in the report and select
Export. (See "Exporting CSV
To change the information displayed in the graphs, follow
Capacity" on page 158.
The final two graphs allow you to view the physical capacity for a specific storage pool or library.
You can also change the graph type from stacked to line. Use the lists to make your selections and
then select Update Graphs.

SAN Health

The SAN Health tab displays information on the number and types of errors encountered on the SAN.
See Figure 38
To export the CSV data, in the Export Data section of the screen enter the number of days to include
in the report and click Export.
When you open the SAN Health tab, the graph at the bottom of the screen displays information for
the top 16 locations from all location categories with the most errors. You can change the information
displayed in the graph:
1. Select a location category.
2. Select the specific locations of interest from the Available Locations box.
3. Using the >> button, move the locations of interest into the Selected Locations box. These are the
locations that will display in the report. You can use the << button to remove locations from the
Selected Locations box.
4. Select another location category and repeat steps 2 and 3.
Data" on page 155 for more information.)
on page 160.
HP StorageWorks 12000 Gateway Virtual Library System User Guide
Step 1, Step 2, and Step 4 in "Logical
159