Configuration Commands; Cli Configuration Commands - HP StorageWorks 12000 User Manual

Configuration Commands

Use the CLI commands in
• Edit the Fibre Channel host port settings
• Enable oversubscription and view oversubscription settings
• View LUN mapping
• Create, view, and destroy virtual libraries, tape drives, or cartridges
• Add, view, or remove barcode templates
Table 6 CLI configuration commands
Command
addNode
discoverArray
updateFC
setOverSubscription
getOverSubscription
getLibTypes
168 CLI Command Set

CLI configuration commands

1
Usage
Add a node to the VLS. See getNodeNames.
Discovers any new arrays added to the VLS.
Changes the default FC host port connection settings. Where the options are:
-a <n> - ID number of node to modify (0, ...) (optional)
-i <n> - FC index (0, 1, ...) (required)
-l <n> - If attached in arbitrated loop mode, specifies a hard ALPA value between
0 and 125. A value of -1 specifies a dynamically assigned ALPA. If not attached
to an arbitrated loop, this parameter is ignored (required)
-r <n> - Port number of the FC port to modify (required)
-s <n> - Preferred speed (0-Auto, 1-One GB, 2-Two GB, 4-Four GB, or 10-Ten
GB) (required)
-t <n> - Preferred topology (0-Auto, 1-Point to Point, 2-Loop, 3-Fabric, or 4-Public
Loop) (required)
-h - Displays command usage information (optional)
Enables or disables oversubscription and specifies the percent storage remaining
for notification. Where the options are:
-e <n> - Enable/disable oversubscription (0-Disabled or 1-Enabled) (required)
-p <n> - Percentage of capacity remaining for alert notification (required)
-h - Displays command usage information (optional)
Returns whether the oversubscription feature is enabled or disabled and the capa-
city remaining percentage for notification alert. Oversubscription is enabled when
enabled = 0. Oversubscription is disabled when enabled = 1.
Returns a list of available library emulation types. Displays each library emulation's
name, type, product, revision, and vendor information. Where the options are:
-l - List only licensed types (optional)
-h - Displays command usage information (optional)
to: