Rebuilding The Virtual Library Configuration; Recreating Vls12000 Gateway Storage Pools - HP StorageWorks 12000 User Manual

2. Add all secondary nodes using the Add Node Wizard. For each secondary node:
a. In Command View VLS, select the System tab.
b. Select Nodes from the navigation tree.
c. Select Add Node from the task bar in the main window. This will bring up the Add Node
Wizard.
d. Verify that the node name in the Node Name field is the next available number that you
configured previously. For example, the primary node, previously configured as Node 0, is
identified as Node 0 in the list of nodes on the navigation tree. The first secondary node
added should be Node 1. The next secondary node added should be Node 2.
e. Select Finish to add the node.
3. Select Chassis in the navigation tree.
4. Click Restore Config under Maintenance Tasks. The Restore Config window opens.
5. Click Browse.
6. Locate and select the desired configuration file.
7. Click Open.
8. Click Next Step. A message displays indicating that the file was uploaded successfully.
9. Click Next to start loading the configuration file.
After the configuration file is loaded, the system automatically applies the configuration and
reboots.

Rebuilding the Virtual Library Configuration

To reconfigure the network settings and rebuild the virtual library configuration:
1. Set the network settings so you can open a Command View VLS session. See
Settings.
2. Rebuild the virtual library and virtual drive configurations and re-enter your other configuration
settings, such as the notification alert settings. See Configuration, Management, and Monitoring.
NOTE:
If the node system board was ever changed and the virtual library configuration and network settings
were not saved to a configuration file, the persistent VLS serial number and Fibre Channel port
WWPNs are lost and cannot be recovered. The VLS firmware will automatically generate a new VLS
serial number and new Fibre Channel port WWPNs based on the node system board's MAC address.
If this occurs, any capacity licenses installed on the VLS will no longer work, as they only work with
the VLS serial number for which they were issued. You can obtain new capacity licenses from HP
technical support using the new VLS serial number. You will also need to reconfigure your SAN to
reflect the new Fibre Channel port WWPNs.

Recreating VLS12000 Gateway Storage Pools

To recreate the storage pools:
1. One storage pool is automatically created. Recreate any other storage pools, as needed. See
Configuring Storage Pools.
HP StorageWorks 12000 Gateway Virtual Library System User Guide
Setting the Network
211