Removing A Hard Drive From A Hard-Drive Carrier - Dell DX6000 Hardware Owner's Manual

1 If present, remove the front bezel. See "Removing the Front Bezel" on
page 81.
2 If a drive blank is present in the bay, remove it. See "Removing a Hard-
Drive Blank" on page 85.
Figure 3-5. Installing a Hot-Swap Hard Drive
1 release button
3 Install the hot-swap hard drive.
Press the button on the front of the drive carrier and open the handle.
a
Insert the hard-drive carrier into the drive bay until the carrier
b
contacts the backplane.
Close the handle to lock the drive in place.
c
4 If applicable, install the bezel. See "Installing the Front Bezel" on page 82.

Removing a Hard Drive From a Hard-Drive Carrier

Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-6.
1
2
2 hard drive carrier handle
Installing System Components
87