Dell DX6000 Hardware Owner's Manual page 53

Table 1-2. System Messages
Message
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x,x,...
Unused memory
detected. DIMM's
installed in the
following slot
are not available
when in mirror or
128-bit advanced
ECC modes: x,x,x
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
Warning: Control
Panel is not
installed.
Warning! No micro
code update
loaded for
processor n.
(continued)
Causes
Invalid memory
configuration. Memory
modules are mismatched in
the specified slots.
The memory configuration is
not optimal for mirroring or
Advanced ECC Memory
Mode. Modules in the
specified slots are unused.
A fatal system error occurred
and caused the system to
reboot.
The control panel is not
installed or has a faulty cable
connection.
Micro code update failed.
Corrective Actions
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 131.
Reconfigure the memory for
Memory Mirroring or
Advanced ECC Memory
Mode, or change the memory
mode to Optimized in the
BIOS setup screen. See
"System Memory" on
page 130.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 155 for
any faulty components
specified in the SEL.
Install the control panel, or
check the cable connections
between the display module,
the control panel board, and
the system board. See
"Control Panel Assembly" on
page 145.
Update the BIOS firmware.
See "Getting Help" on
page 189.
About Your System
53