Sas Backplane (Service Only Procedure); Removing The Sas Backplane - Dell DX6000 Hardware Owner's Manual

3 Connect the display module cable to the control panel board.
4 Connect the control panel cable to the control panel board.
5 Connect the internal SD module cable.
6 Install the internal USB memory key.
7 Close the system. See "Closing the System" on page 83.
8 Reconnect the system to the power source and turn on the system and
attached peripherals.

SAS Backplane (Service Only Procedure)

Removing the SAS Backplane

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 If applicable, remove the bezel. See "Removing the Front Bezel" on
page 81.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening the System" on page 83.
CAUTION:
SAS drives from the system before removing the backplane.
CAUTION:
them before removal to ensure that you can replace them in the same locations.
4 Remove all hard drives. See "Removing a Hot-Swap Hard Drive" on
page 86.
5 Disconnect the power cable from the end of the SAS backplane.
6 Disconnect the SAS data cables from the backplane.
7 While pulling the blue latch toward the front of the system, slide the
backplane upward. See Figure 3-30.
148
Installing System Components
Many repairs may only be done by a certified service technician.
To prevent damage to the drives and backplane, you must remove the
You must note the number of each hard drive and temporarily label