6. Install and lock the side cover (see "Reinstalling the side cover" on page 54).
7. Reconnect the external cables and power cords; then, turn on the attached
Installing an IBM Remote Supervisor Adapter II SlimLine
An optional IBM Remote Supervisor Adapter II SlimLine must be installed only in its
dedicated connector on the system board. See "System-board optional-device
connectors" on page 18 for the location of this connector on the system board. After
you install the Remote Supervisor Adapter II SlimLine, the systems-management
Ethernet port on the rear of the server is active.
To install a Remote Supervisor Adapter II SlimLine, complete the following steps:
Mini-PCI slot
Mini-PCI-X enablement
card
Mini-PCI-X enablement
card connector
devices and turn on the server.
1. Read the safety information that begins on page v and "Installation guidelines"
on page 20.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Lay the server on its side.
4. Unlock the side cover.
5. Remove the side cover (see "Removing the side cover" on page 24).
6. Open the rear adapter-retention bracket and install the Remote Supervisor
Adapter II SlimLine retention tab on the bracket by clipping it onto the rear
adapter-retention bracket.
Chapter 2. Installing optional devices
47