Reinstalling The Side Cover - IBM 436854u - System x3200 M2 5U Mini Tower Server User Manual

Reinstalling the side cover

If you removed the bezel, reinstall it before you reinstall the side cover. See
"Reinstalling the two-piece bezel" on page 52.
Note: The rear adapter-retention bracket rests against the server side cover. You
might find it easier to lay the server on its side to replace the side cover.
To reinstall the side cover, complete the following steps:
1. Before you install the side cover, make sure that all cables, adapters, and other
2. Position the lip on the bottom edge of the side cover on the ledge on the bottom
3. Close the cover-release latch to secure the side cover in place.
4. Lock the side cover.
54
System x3200 M2 Types 4367 and 4368: User's Guide
components are installed and seated correctly and that you have not left loose
tools or parts inside the server. Also, make sure that all internal cables are
correctly routed.
Note: The cover-release latch must be in the unlocked (opened) position before
you install the side cover.
of the chassis; then, rotate the cover up to the chassis, and then press down on
the cover release latch and push the cover completely closed until it latches
securely into place.
Cover-release
latch
Key lock