Installing A Tape Drive - IBM 436854u - System x3200 M2 5U Mini Tower Server User Manual

10. Connect one end of the applicable signal cable into the rear of the drive and
11. Route the signal cable so that it does not block the airflow to the rear of the
12. If you have another drive to install or remove, do so now.
13. Connect the power cable to the rear of the drive. The connectors are keyed
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 52.

Installing a tape drive

To install a tape drive, complete the following steps:
34
System x3200 M2 Types 4367 and 4368: User's Guide
9. If you are installing a 5.2-inch drive in bay 2, slide the drive into the bay. If you
are installing a 3.5-inch drive in bay 2, you must attach the 5.2-inch.
conversion kit to the 3.5-inch drive.
Note: An optional diskette drive can be installed in bay 3.
make sure that the other end of this cable is connected into the applicable
SATA connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
and can be inserted only one way.
1. Read the safety information that begins on page v and "Installation guidelines"
on page 20.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Remove the side cover (see "Removing the side cover" on page 24).
4. Remove the two-piece bezel (see "Removing the two-piece bezel" on page
25).
5. Use a screwdriver to pry the filler panel and EMC shield away from the server.
6. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.