Using The Enclosed Software; Restoring The Factory Default Settings - Canon VB101 User Manual

Using the Enclosed Software

Restoring the Factory Default Settings

Use the "IniVB101.exe" and "inivb101.elf" files in the same directory on the enclosed CD-ROM to
restore the VB101 settings to the factory default values.
1
2
Select direct connection to COM1 as the connection method.
1
Enter the password (the default setting is "VB101").
3
G Refer to P.162 for the factory default settings.
c
Note
160
Connect the VB101 to your PC (→ P.33), insert the enclosed CD-ROM
into the CD-ROM drive and launch the "IniVB101.exe" program.
When the "IniVB101.exe" dialog box appears, perform steps
below to restore the factory default settings.
GThe factory default setting are
restored
G When you click the [Cancel] button after switching the VB101 back on, the
power LED remains lit orange. At this point, the VB101 software has not
started up. If you do not need to change the settings, switch the VB101 to
off and then on again and check that the power LED is green. To begin the
setup procedure again, launch "IniVB101.exe" and then switch the VB101
off and on again as directed by the on-screen instructions.
G If you forget the password, you will have to return the VB101 to a service
center. Please contact your Canon dealer.
G On some PCs you may have to select a port other than COM1.
Check the port number to which the serial cable is connected.
Switch the VB101 off and then
2
on again.
G When you switch the VB101 on again,
the [Next] button is enabled.
When the confirmation message
4
appears, click the [OK] button.
to