Initial Setup - Canon VB101 User Manual

Initial Setup

Connect the VB101 to the PC to
1
be used for initial setup by
using bundled RS-232C cable.
Switch the VB101 and the PC on.
2
Unplug the power cord, then plug it in again.(→ P.24)
Insert the CD-ROM
3
supplied with the VB101
into the PC and launch
the "VB101_IP.exe"
program.
When the "VB101_IP.exe" dialog box appears, use steps
4
below to enter the password, IP address (192.168.100.1 is
used here as an example), subnet mask, and gateway address.
Select the connection port.
1
Enter "VB101" (Factory default
3
setting) as the password .
G Set the IP address to a value that suits your environment.
c
G Assign a fixed IP address to the VB101.
Note
G When you click the [Cancel] button after switching the VB101 back on, the
Power LED remains lit orange. At this point, the VB101 software has not
started up. If you do not need to change the settings, switch the VB101 off
and then on again, and check that the Power LED turns green. To begin the
setup procedure again, launch "VB101_IP.exe" and then switch the VB101
off and on again as directed by the on-screen instructions.
G If power is turned on before the initial settings have been made, the Power
LED illuminates in orange, but this does not indicate a malfunction. (→ P.21)
VB101
RS-232C cable to
be used for setup
Switch the VB101 off and then
2
on again.(→ P.24)
On some PCs you
may have to select a
port other than COM1.
Check the port number
to which the serial
cable is connected.
Enter the IP address, subnet mask,
4
and gateway address.
The password can be
changed on the
System Settings page.
(→ P.39)
PC
Enclosed CD-ROM
to
3
33