JVC VN-A1U - Network Encoder Instructions Manual page 37

6-7 Making the set IP address valid
When the IP address is changed, the pan and tilt mechanism will
work and the IP address becomes valid after the VN-A1U is reset.
6-8 Special Notes on the V.NETWORKS Setup Tool
CAUTION
The V.NETWORKS Setup Tool is software that is only required when the setup is
performed. Therefore, please uninstall the software following completion of the
setup unless there is special reason for leaving it on the PC. When setting the
second or following units, reboot the PC and then return to 1 (page 16). After
setting of all the VN-A1U units is completed, proceed with the next procedure.
Restoring a work PC IP address
Using the same procedure as in 4-1, select Settings from the Start button,
then select Control Panel and Network, Change to the original TCP/IP
properties setting that you made a note and then restore a work PC IP address.
After restoration is completed, follow the messages of OS and reboot the PC.
SEARCH FUNCTION
The Search button is used to find the V.NETWORKS IP addresses currently
connected to the network.
When Search button is pressed, the Search screen will be displayed.
When Start Search button is pressed, a list of the V.NETWORKS IP
addresses currently connected to the network will be displayed. Timeout
is used to set the search time and can be set to 0 - 30 sec.
CAUTION
When your own PC and a V.NETWORKS of a different subnet are
connected on a LAN, connection will not be possible even if the search is
successful.
In such cases, change to an appropriate IP address on your PC and then
try connection.
37