Vn-A1U Setup; Before Starting Setup - JVC VN-A1U - Network Encoder Instructions Manual

VN-A1U Setup

Before starting setup

It is necessary to set an IP address for each VN-A1U unit. Use the following
procedure for the setup of each unit. (If the power is not turned on, the
installation of multiple VN-A1U can be performed at one time.)
1. Install the VN-A1U
* In case of installation in a location where the power cannot easily be
turned on, complete steps 2 - 5 before step 1.
2. Connect the VN-A1U to the network.
(The power to the VN-A1U should be ON.)
3. Set the VN-A1U IP address.
* When setting the VN-A1U IP address, be sure to contact the network
administrator for assignment or approval. When installing the second
and following units, reboot the PC and then return to step 2.
4. Enable the VN-A1U IP address.
(Turn the VN-A1U power off and then on again.)
5. Register the connection point.
* This registers the VN-A1U IP address data in the PC.
13