Canon VB-C300 Start Manual page 30

Connect the Camera to the Network and Perform the Initial Setting
When using external power supply
When using external power supply, use the Power
Connector (→ P.vi) supplied with the camera as shown
to the right.
Supply 12VDC or 24VAC from a power supply
insulated from 100-240VAC supply. You can connect
12VDC power supply without regard to the polarity.
When using an external power supply, make sure that
the voltage falls within the ranges below.
AC24V: Voltage fluctuation within AC24V±10%
Current supply capability over 1.0A per camera
DC12V: Voltage fluctuation within DC12V±10%
Current supply capability over 1.5A per camera
* If using a DC12V battery power source, make sure to use the DC12V by connecting a resistor
that is between 0.5 and 1.0Ω, and over 20W in series to the power supply line.
Recommended power supply cables for VB-C300 [for reference]
Cable (AWG)
Conductor diameter
(ømm)
12VDC
Maximum cable length (m)
Maximum cable length (ft)
24VAC
Maximum cable length (m)
Maximum cable length (ft)
Use a UL cable (equivalent to UL-1015) as the power cable for 12VDC or 24VAC.
● The camera head position is automatically initialized when the power supply is
turned ON.
Note
● Never touch the camera head while its position is being initialized. If you touch it,
the head position may not be initialized correctly, or other malfunctions may result.
● Wait at least 5 seconds before turning the power back on after shutting it off. Turning
it on too quickly may result in a malfunction. Observe the precautions given in
"Safe Use of Equipment/IMPORTANT SAFETY INSTRUCTIONS (
Use of Equipment/When using the camera with PoE HUB (
and unplugging the power cable.
● Read the manual of the PoE HUB for how to power it ON or OFF.
● You can connect the AC adapter (optional) to the camera while it is powered from the
PoE HUB. In this case, the PoE-supplied power is used while it is active, and the
power from the AC adapter (optional) is not used. When the PoE-supplied power is
disconnected, the power supply automatically switches to the AC adapter (optional).
2-6
#24 #22
(0.52mm) (0.65mm)
(0.020inch) (0.026inch)
5 9
16.4 29.5
11 18
36.1 59.0
The network connection is now complete.
Screwdriver
approx. 4mm - 6mm
(0.16inch - 0.24inch)
Power
Connector
(Supplied)
#20 #18
(0.82mm) (1.03mm)
(0.032inch) (0.041inch)
14 23
45.9 75.4
29 46
95.1 151.0
→
→
P.xii) when plugging
Stripping length
#16
(1.30mm)
(0.051inch)
32
105.0
64
210.0
P.viii, x), "Safe