[Camera] > [Initial Setting] Setting Initial Video Settings; Camera Position - Canon VB-R13VE Operation Manual

[Camera] > [Initial Setting]
Setting Initial Video Settings
Sets initial settings, such as video quality compensation, at camera start up. If you change settings, the changes are
immediately reflected in the video display area and Viewer, even if you do not click [Apply].
A message confirms whether you want to display the current camera status as the initial settings if the current camera
status differs from the settings registered as the initial settings when you access [Initial Setting].
If you click [OK], the current camera status is displayed as the initial settings. If you click [Cancel], the current camera
status is ignored and the settings registered as the initial settings are displayed.

Camera Position

Sets the camera position at camera start up.
H652
Important
If you change the zoom after configuring the intelligent function, privacy mask, preset, and ADSR, those settings must be configured
again.
R13 R12
Note
You can operate the frame on the panorama screen or the video display area to perform pan, tilt, and zoom operations.
[Pan/Tilt/Zoom position]
Register the present pan, tilt, and zoom positions as the initial setting. If you select [Unregister], the camera will return to the
pan, tilt, and zoom positions as when the camera was turned off the next time it is booted.
M50
Note
When [Digital PTZ Position] is set to [Unregister], you can perform pan, tilt, and zoom operations on the video display area using Area
Zoom (P. 69).
[Digital PTZ Position]
Register the current digital PTZ position as the initial setting.
If you select [Register], a yellow frame is displayed in the video display area. Operate the frame to specify the Digital PTZ
trim position during startup.
112
H651
M50
R13 R12 M50
M50 H652 H651
The following settings can be configured here.
• Camera position
• Camera Settings