[Camera] > [Initial Setting] Setting Initial Video Settings; Camera Position - Canon VB-S800VE Operation Manual

[Camera] > [Initial Setting]
Setting Initial Video Settings
Sets initial settings, such as video quality compensation, at camera start up. If you change settings, the changes are
immediately reflected in the video display area and Viewer, even if you do not click [Apply].
A message confirms whether you want to display the current camera status as the initial settings if the current camera
status differs from the settings registered as the initial settings when you access [Initial Setting].
If you click [OK], the current camera status is displayed as the initial settings. If you click [Cancel], the current camera
status is ignored and the settings registered as the initial settings are displayed.

Camera Position

Sets the camera position at camera start up.
S30VE
[Pan/Tilt/Zoom position]
Register the present pan, tilt, and zoom positions as the initial setting. You can operate the frame on the panorama screen
or the video display area to perform pan, tilt, and zoom operations.
If you select [Unregister], the camera angle will move to the home position the next time it is booted. If you have not
specified the home position, the camera angle will move to the factory default setting. For information on specifying the
home position, please refer to P. 118.
S30VE
Note
When [Digital PTZ Position] is set to [Unregister], you can perform pan, tilt, and zoom operations on the video display area using Area
Zoom (P. 61).
S910F
[Zoom Position]
Register the present zoom positions as the initial setting. You can operate the zoom position using the slider or the full-view
screen of the right side on the screen.
If you select [Unregister], the camera will return to the zoom positions as when the camera was turned off the next time it is
booted.
The following settings can be configured here.
• Camera position
• Camera Settings
4
103