Set Up The Camera; When Mounting On The Ceiling - Canon VB-C300 Start Manual

Set Up the Camera

Before Setting Up the Camera
Be sure to define the IP address (
● If 20 minutes or more have passed since the VB-C300 was turned on, the VB-
C300 stops sending requests for IP addresses allocation and they cannot be
Note
detected using the VB Initial Setup Tool. Therefore, specify the IP address and
confirm the camera operation before setting up the camera as directed in "Initial
setting of the Camera" (→ P.2-7).
● The permissible camera installation angles are ±20° from the horizontal.
● The MAC address for this unit is shown on the bottom of the VB-C300 (→ P.1-8).
Please make a note before installing this unit.
● When holding the camera, hold it with the head arm but not the camera head.
● The unit cannot be installed in locations subject to direct sunlight, high temperatures,
high humidity, or other adverse conditions (→ P.x).

When Mounting on the Ceiling

Follow the steps below to mount the camera on the ceiling. Install the camera securely.
a WARNING:
Install the camera securely.
● When installing the VB-C300 on the ceiling, contact your Canon dealer.
● When installing the VB-C300 on the ceiling, check that the ceiling is strong enough
to bear the weight of the VB-C300 including the Ceiling Bracket. Installation in a
weak location could result in the VB-C300 falling and causing serious injury.
● At least once a year, check for looseness in the camera installation mount.
● When routing the cables, pay much attention not to damage the indoor wiring or
piping.
Side View of mounting
Roof space
2-14
Safety Wire
Fix to an anchor
or structure
A B
IN-1 IN-2 OUT
Ceiling Bracket
→
P.2-7) before installing the camera.
OUT
VIDEO 100/10BT
OUT IN
24V IN AC
LINE LINE
12-13V IN DC
VB-C300
LAN cable
Ceiling board